TRIPLE BEAM BALANCE
Cat No. VE/BLA/00010 A A single pan, low from beam that will weigh upto 2610 gm when used with supplementary masses. The balance has three notched weighing beams with center indicating sliding masses, giving total weighing capacity of 610gm. Additional … Click Here And Read Rest Below
TRIPLE BEAM BALANCE
Cat No. VE/BLA/00010 A single pan, low from beam that will weigh upto 2610 gm when used with supplementary masses. The balance has three notched weighing beams with center indicating sliding masses, giving total weighing capacity of 610gm. Additional masses … Click Here And Read Rest Below
LEVER (LETTER) BALANCE
Cat No.VE/BAL/00009 The balance frame is of aluminium casting having three point base with a leveling screws.The dual range are scale 0-250 gms x 1gm division and 0-1 Kg x 10gms. With removable pan. The changeover is effected by a … Click Here And Read Rest Below
FOUR BEAM (SUSPENDED PAN) BALANCE
Cat No.VE/BAL/00008 A 4 beam balance with a suspended pan. Weighing capacity 311g.Sensitivity 0.01g. Height of stirrup approx 190mm. Beams notched. Four beams each provided with a slider, and graduated 0-200g x 100g, 0-100g x 10g, 0-10g x 1 g … Click Here And Read Rest Below
Cat No. VE/BAL/00007 Features: Auto shut off. Auto calibration. Auto zero tracking. Auto backlight. Low battery indication. Kg/g/oz conversion. Large LCD (6 digits 15mm height). Large Square weighing pan. Net weight/stability indication. 1/2000, 1/5000 & 1/15000 division available. Cat. No. … Click Here And Read Rest Below
CAT. No. VE/PHY/00150
Horizontal: Searle’s pattern, two cast iron feet each with 3 through holes and grub securing screws, separated by 2 supporting rods approximately 700 mm long one of which is graduated in cms and mms, wheel 165 mm dia, over groove moving in ball bearings, mounted on front foot, with spindle carrying split collect chuck for holding one end of test rod 55 cms long 5 mm dia, other end supported with clamping block through rear foot. With two aluminium scales graduated 30-0-30 in single degrees, mounted onpillar supports, which are adjustable along the rod, two pointers with clamp for attaching to specimen, one each of Brass and Steel rods, cord and hook for carrying masses but w/o weights.
Vertical : It consists of a heavy mild steel frame mounted on a heavy trileg cast iron base. Upper end of the rod 900 mm length and 5 mm dia under test is clamped by a 3-jaw chuck and the lower end is clamped, into the axis of a torsion couple three metal circular scales graduated in single degrees which are free to slide on one of the graduated rod can be clamped at any position. Three pointers for clamping to the test rod are provided. Strings to apply the deflecting couple and having pans at their free and pass over bearing pulleys which are clamped to the uprights without weights.